Modulated DSC for gas hydrates analysis

Modulated DSC has been applied to the study of methane, ethane and propane hydrates at different hydrate and ice concentrations. The reversing component of the TMDSC curves, makes it possible to characterize such hydrates. Methane and ethane hydrates show the melting-decomposition peak at a temperatures higher than the ice contained in the sample, while propane hydrate melts and decomposes at lower temperature than the ice present in the sample. The hydrate peaks tend to disappear if the hydrate is stored at atmospheric pressure. Guest size and cavity occupation fix the heat of dissociation and stability of the hydrates, as confirmed by parallel tests on tetrahydrofurane hydrates.     

Self‐curable polyester by a reaction of glycidol with maleic anhydride

The controlled reaction of equimolar quantities of maleic anhydride and glycidol in dimethoxyethane gives soluble polyesters with one hydroxyl group in each repeating unit. The reaction proceeds with stepwise ring opening of the components and gives highly viscous clear solutions in relatively short periods. In the first step, monomaleate ester formation takes place around 80 °C. The ring opening of the oxirane group is the second step, and it occurs at 120 °C. The overall reaction is the formation of soluble polyesters with moderate molecular weights (6000–18,000), without the elimination of water. The soluble polyesters can be crosslinked tightly by direct heating at 190 °C without additional vinyl monomer. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 2549–2555, 2003     

Morphologies of microporous polyethylene and polypropylene crystallized from solution in supercritical propane

The morphologies of solvent-free, microporous, mechanically self-supporting cylinders of linear polyethylene and isotactic polypropylene, crystallized from solution in supercritical propane, were examined by an SEM technique. The morphology of gels (or foams), obtained with little or no shrinkage from 2% to 35% solutions by weight of polyethylene (99% to 85% porosities), is shown in some detail. Lamellae with very little or considerable mutual organization occur, often in the form of stacks with straight or coiled axes (axialites). Further growth of these can lead to particles with a roughly spherical overall shape and a predominantly radial orientation of the lamellae at the particle surface. Subcooled isotactic polypropylene, on the other hand, crystallizes in the form of perfectly shaped birefringent microspheres of very uniform size. ©1995 John Wiley & Sons, Inc.     

双甲基丙烯酰氧苯基丙烷与苯乙烯共聚物的光学性能

标题共聚物的耐冲击性与丙烯酸酯均聚物相比有明显改善,但随着双烯单体含量的降低,共聚物的耐热性和表面硬度有所下降。丙烯酸酯含量为70%的共聚物的吸收紫外光能力最强(<370nm全吸收),含量为5%～10%的共聚物耐吸水性、耐酸耐碱性及耐冲击性最好。     

Preparation of AgBiVMoO/-Al2O3 Catalysts for the Partial Oxidation of Propane

A novel mixed sol method was developed for the preparation of supported catalysts. Analyses by means of XRD and BET show that a 40%AgBiVMoO/γ-Al2O3 catalyst prepared by this method possessed high specific surface area and high dispersion of the active phase. As a result, high acrylic acid selectivity of 8.5% was obtained when the catalyst was used in the reaction of propane partial oxidation to acrylic acid in a fixed-bed reactor.     

四（五氟化苯基）卟啉氯化铁选择催化氧化超临界丙烷的反应机理

 以BHT为自由基捕捉剂，研究了四（五氟化苯基）卟啉氯化铁（Ⅲ）将超临界丙烷高选择性催化氧化为丙醇的反应机理．通过GC－MS分析发现，反应产物中有PBHT，故可认为在超临界丙烷氧化反应过程中有丙基自由基存在，初步推断反应涉及自由基机理．同时发现高浓度BHT抑制反应，低浓度BHT促进反应的现象，而以戊烷为底物时没有促进作用．这是由于BHT的位阻效应所致．并对BHT存在时超临界丙烷氧化反应机理进行了初步的推断．     

Kinetics of the Oxidative Dehydrogenation of Propane over a VMgO Catalyst

The reaction kinetics of the oxidative dehydrogenation of propane was studied at 475-550℃ over a VMgO catalyst. Vanadium-magnesium-oxides are among the most selective and active catalysts for the dehydrogenation of propane to propylene. Selectivity to propylene up to about 60% was obtained at 10% conversion, but the selectivity decreased with increasing conversion. No oxygenates were detected, the only by-products were CO and CO2. The reaction rate of propane was found to be first order in propane and close to zero order in oxygen, which is in agreement with a Mars van Krevelen mechanism with the activation of the hydrocarbon as the rate determining step. The activation energy of the conversion of propane was found to be 122±6 kJ/mol.     

系数倍率导数分光光度法测定邻氯苯亚甲基丙二腈和邻氯苯甲醛

本文提出一种新的光度法——系数倍率导数分光光度法,用于邻氯苯亚甲基丙二腈和邻氯苯甲醛的测定,回收率分别为97.6～102.0％和97.5～104.2％。实验结果表明方法快速、准确、可靠。     

铂锡双金属催化剂上丙烷脱氢反应研究

对比研究了Ｓｎ／Ｐｔ比为１；１，２，：１和５：１的原子簇担载于γ－Ａｌ２Ｏ３上制成的Ｐｔ＝Ｓｎ原子簇催化剂，和用ＳｎＣｌ２和Ｈ２ＰｔＣｌ６浸渍制备的相应Ｓｎ／Ｐｔ比的催化剂对丙烷脱氢生成丙烯的催化性能。     

Mg改性对Co/γ-Al2O3-TiO2催化燃烧丙烷性能影响

采用分步浸渍法制备了系列Mg改性的Co/γ-Al_2O_3-TiO_2催化剂,通过X射线衍射(XRD)、紫外可见漫反射光谱(DR-UV-vis)、N_2吸附-脱附(BET)、X射线光电子能谱(XPS)和H_2程序升温还原(H_2-TPR)等技术对催化剂进行表征,并考察了其对丙烷燃烧的催化性能。结果表明,Co在原始γ-Al_2O_3-TiO_2载体和Mg改性MgO/γ-Al_2O_3-TiO_2载体上均以Co_3O_4的形式存在;Mg掺入后与Al_2O_3作用形成MgAl_2O_4尖晶石,改善了载体的织构性质,提升了Co_3O_4在催化剂载体表面的暴露数量和分散程度。此外,MgAl_2O_4与Co_3O_4相互作用提升了Co_3O_4颗粒表面Co~(3+)/Co~(2+)和O_(ads)/O_(latt)的比例,并削弱了Co-O键键能,从而提升了其对丙烷的催化燃烧活性。当Mg负载量为15%(质量分数)时,在Co/MgO(15%)/γ-Al_2O_3-TiO_2催化剂上进行丙烷燃烧,丙烷90%转化率的温度比无Mg掺杂的Co/γ-Al_2O_3-TiO_2催化剂的降低了45℃,并且连续反应40 h其活性保持稳定。